MID-IR LED Driver specification

Home

Catalog

Support

About US

Product Catalog

MID-IR

Drivers

LED Driver - Model D-31

Driver D-31 is designed for power supply of all models Mid-IR LED's. Driver provides two modes of operation:

Quasi Continuous Wave (quasi steady-state) mode: This mode provides maximum average optical power from the LED. Current in this mode can be changed in the range 0-400 mA. One of four frequences (0.5 kHz, 2 kHz, 8 kHz and 16 kHz) can be selected.

Pulse mode: This mode provides maximum peak optical power from the LED. In this mode besides changing of frequency, pulse duration can be also selected in the range 0.6-20 ms. Peak current in pulse mode can be changed in the range 0-2 A. Please, don't use combination of frequency and pulse duration that gives duty cycle >10%. We recommend using of 2 A pulse current only at pulse duration <1 µs.

Parameters Pulse mode Quasi-CW mode

Pulse duration 0.6-20 µs 31-1000 µs

Repetition rate 0.5-16 kHz 0.5-16 kHz

Current amplitude 0-2 A 0-400 mA

Dimensions, mm 105x58x20

Weight 90 g

Power requirement +12 V DC

Laser Diode / LED Driver with Temperature Controller - Model DLT-27

Driver DLT-27 is designed for power supply of all models Mid-IR LED’s with built-in thermocoolers. Driver provides two modes of operation: 1. Quasi Continuous Wave (quasi steady-state) mode. Such mode provides maximum average optical power from the LED. Current in this mode can be changed in the range 20-400 mA. Frequence of modulation is 16 kHz. 2. Pulse mode. Such mode provides maximum peak optical power from the LED. Peak current in pulse mode can be changed in the range 0-2 A. Pulse duration is 1 μs
Temperature controller that is built in DLT-27 provides selecting and stabilizing of the temperature on LED's chip in wide range. That gives possibility to tune wavelength or optical power.

Preamplifier for Photodiodes

Photodiode Preamplifier - Model AM-07

Amplifier AM-07 converts the current output of a signal source such as for example Mid-Infrared photodiode, into a voltage output with amplification of the voltage for subsequent use with various electronic systems, like lock-inamplifiers, oscilloscopes or A/D converters. In the same package is included also Sinchrodetector that gives direct current proportional to the signal at selected frequency. Customer can see the signal on LC Display.

Photodiode Amplifier with Temperature Controller - Model AMT-07

Amplifier AMT-07 converts the current output of a signal source such as for example Mid-Infrared photodiode, into a voltage output with amplification of the voltage for subsequent use with various electronic systems, like lock-inamplifiers, oscilloscopes or A/D converters. In the same package is included also Sinchrodetector that gives direct current proportional to the signal at selected frequency. Customer can see the signal on LC Display.

Amplifier AMT-07 is designed for operation with photodiodes with built-in termocooler and thermistor (Models PDXX-XX-TEC). Customer can select and set the temperature of PD operation. Circuit with feedback will set the necessary thermocooler current for maintaning the selected temperature.

Prices

Device	Price			Datasheets
Device	1+	10+	50+	Datasheets
LED Driver D-31	$197	$188.5	$180	Datasheet
LED Driver with Temperature controller DLT-27	call	call	call	Datasheet
Preamplifier AM-07	call	call	call	Datasheet
Preamplifier with Temperature controller AMT-07	call	call	call	Datasheet

Reduced price based on the quantity is available. For a quote on a large order, pleas send email to sales@microsensortech.com